LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1991 >> Precis Base, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.5L 4-CYL - VINS [A,J,X] & 1.6L 4-CYL - VIN [Y] >> Removal & Installation >> Rear Crankshaft Oil Seal >> Installation

Rear Crankshaft Oil Seal: Installation

  1. On 1.6L engines, install oil separator plate into oil seal case. Oil hole in oil separator plate should be located at bottom of oil seal case, toward oil pan sealing surface.
  2. Install seal in oil seal case until it bottoms. On 1.5L engines, use Seal Installer (09231-21000 for Precis and MD998011 for all others). On 1.6L engines, use Seal Installer (MD998376). Install oil seal case with new gasket. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals