Front Disc Brake Rotor (Van/Wagon, 2WD Pickup): Installation

To install, reverse removal procedure. Tighten wheel bearings to 22 ft. lbs. (30 N.m). Loosen nut and then retighten to 72 INCH lbs. (8 N.m). Install cotter pin. If pin does not align, loosen nut 30 degrees maximum.

Fig 1: Removing Hub From Steering Knuckle (Mirage)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Exploded View of Front Brake Assy (Montero, 4WD Pickup)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.