LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1990 >> Eclipse Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL - VIN (T), 2.0L VIN (R,U,V) & 2.4L VIN (W) 4-Cylinder >> Removal & Installation >> Rear Crankshaft Oil Seal >> Installation

Rear Crankshaft Oil Seal: Installation

  1. To install, coat seal lip with oil. Using Seal Installer (MD998011 for 1.8L, or MD998376-01 for all others), install seal in seal case until it bottoms.
  2. Install oil separator in seal case, with hole of separator at bottom of seal case (toward oil pan). Install seal case and gasket. Install flywheel or drive plate and transmission.
scientia non olet · About LEMON Manuals