LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1990 >> Eclipse Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL - VIN (T), 2.0L VIN (R,U,V) & 2.4L VIN (W) 4-Cylinder >> Removal & Installation >> Intake Manifold >> Removal (2.4L)

Removal (2.4L)

  1. Release residual fuel pressure from fuel system. See FUEL PRESSURE RELEASE .
  2. Remove driver's seat and battery access cover. Lift and support passenger's seat. Remove parking brake lever and fuel tank door release lever. Remove seat underframe (section between seats).
  3. Disconnect negative battery cable. Drain cooling system. Disconnect air intake hose from air intake pipe. Disconnect the following from intake manifold, injectors and throttle body: all necessary electrical connectors, vacuum hoses, coolant hoses, fuel hoses and cables. See Figure.
  4. Remove air intake pipe and throttle body. Remove air intake plenum from intake manifold. Remove fuel delivery pipe with fuel injectors and pressure regulator attached. DO NOT  allow fuel injector to fall from delivery pipe during removal.
  5. Remove ignition coil, thermostat and distributor. Remove intake manifold-to-cylinder block support brace. Remove intake manifold.
scientia non olet · About LEMON Manuals