LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1990 >> Eclipse Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL - VIN (T), 2.0L VIN (R,U,V) & 2.4L VIN (W) 4-Cylinder >> Overhaul >> Cylinder Block

Cylinder Block

  1. Check cylinder block head surface warpage. If warpage exceeds specification, machine surface. DO NOT  remove more than a combined total .008" (0.20 mm) material from original surfaces of cylinder head or cylinder block. See CYLINDER BLOCK SPECIFICATIONS  table.
  2. Check cylinder bore wear and taper. Measure cylinder bore diameter at the following 3 places: .47" (12 mm) from top of bore, .47" (12 mm) from bottom of bore, and near center of bore. If cylinder bore diameter or taper is not within specification, machine cylinder bore.
scientia non olet · About LEMON Manuals