LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1990 >> Eclipse Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL - VIN (T), 2.0L VIN (R,U,V) & 2.4L VIN (W) 4-Cylinder >> Engine Lubrication >> Oil Pump & Front Cover >> Installation (2.0L DOHC)

Installation (2.0L DOHC)

  1. Lubricate oil pump gears with engine oil and install. Ensure timing marks are aligned. Install oil pump cover and tighten bolts to specification. See TORQUE SPECIFICATIONS .
  2. If crankshaft oil seal was removed, use Seal Installer (MD998375) to install seal in front cover. Use a socket of proper diameter to install silent shaft oil seals.
  3. Position Oil Seal Guide (MD998285) over front of crankshaft. Lubricate crankshaft oil seal and oil seal guide with engine oil. Install front cover with new gasket and temporarily tighten bolts. Install oil filter bracket. Ensure bolts of appropriate length are installed.
  4. To install remaining components, reverse removal procedure. Install plug cap using new "O" ring and tighten to specification. Apply thread sealant to switch threads before installing. Tighten all bolts to specification.
scientia non olet · About LEMON Manuals