LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1990 >> Eclipse Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL - VIN (T), 2.0L VIN (R,U,V) & 2.4L VIN (W) 4-Cylinder >> Engine Lubrication >> Oil Pump & Front Cover >> Installation (1.8L Eclipse)

Installation (1.8L Eclipse)

  1. If crankshaft oil seal was removed, use Seal Installer (MD998304) to install seal in front cover. Use a socket of proper diameter to install silent shaft oil seal.
  2. Position Oil Seal Guide (MD998285) over front of crankshaft. Lubricate crankshaft oil seal and oil seal guide with engine oil. Install front cover with new gasket. Ensure bolts of appropriate length are installed.
  3. Install oil pump gears with timing marks aligned. Lubricate gears with engine oil. To install remaining components, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS  table. Install oil pump cover gasket with rounded side toward oil pump cover.
scientia non olet · About LEMON Manuals