LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1989 >> Precis Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.5L 4-CYL - VINS [J,X] & 1.6L 4-CYL - VINS [Y,Z] >> Removal & Installation >> Camshaft >> Removal (1.6L)

Removal (1.6L)

  1. Remove timing belt and camshaft sprocket. See TIMING BELT  under CAMSHAFT. Remove crank angle sensor from rear of intake camshaft.
    CAUTION: Bearing cap direction of installation and location must be noted prior to removing bearing caps. Bearing caps are numbered for location and stamped with a letter to indicate which camshaft the bearing cap should be installed on. The letter "L" indicates intake camshaft and "R" indicates exhaust camshaft. The No. 1 bearing cap only contains the letter for camshaft application.
  2. Remove front and rear bearing caps and camshaft oil seals. See Figure. Remove remaining bearing caps in the following sequence: No. 5, 2, 4 and 3. Remove camshaft.
scientia non olet · About LEMON Manuals