LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1989 >> Precis Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.5L 4-CYL - VINS [J,X] & 1.6L 4-CYL - VINS [Y,Z] >> Overhaul >> Rear Main Oil Seal >> Installation

Rear Main Oil Seal: Installation

  1. On 1.6L models, install oil separator plate in oil seal case so that oil hole of oil separator plate is located at bottom of oil seal case (toward oil pan sealing surface).
  2. Using seal installer, install seal in oil seal case until it bottoms. On 1.5L models, use Seal Installer (09231-11000) for Precis models or (MD998011) for Mirage. On 1.6L models, use Seal Installer (MD998376-01).
  3. Install oil seal case using new gasket. To install remaining components, reverse removal procedure.
scientia non olet · About LEMON Manuals