Front Disc Brake Rotor (Montero & 4WD Pickup): Installation

1. To install, reverse removal procedure. Using dial indicator, check drive axle end play. End play must be adjusted during reassembly if not within .008-.020" (.20-.50 mm). Rotate drive axle forward and rearward until maximum end play is obtained.
2. If axle shaft end play requires adjustment, select proper shim to obtain proper end play. Shim is located behind snap ring on end of drive axle. Install shim and recheck axle end play.

Fig 1: Exploded View of Montero & 4WD Pickup Front Brake Assembly

Courtesy of CHRYSLER MOTORS.