LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1988 >> Starion ESI-R, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.6L 4-CYL - VIN [E] & 2.6L 4-CYL Turbo - VIN [N] >> Removal & Installation >> Engine >> Removal (Except B2600, Conquest & Starion)

Removal (Except B2600, Conquest & Starion)

  1. Disconnect negative battery cable. Remove hood and air cleaner. Disconnect all vacuum hoses, fuel hoses and electrical connectors. Drain colling system, transmission, transfer case (if equipped) and engine oil.
  2. Disconnect coolant hoses and remove radiator. Disconnect all control cables. Disconnect oil lines at power steering pump. Discharge A/C system and remove lines at A/C system and remove lines at A/C compressor.
  3. On Montero and Raider models, remove clutch release cylinder from transmission. On all other models, disconnect clutch cable. On all models, disconnect O2 sensor and remove front exhaust pipe.
  4. Remove undercover and other protective transmission covers (if equipped). Disconnect speedometer cable, electrical connectors and hoses at transmission and transfer case.
  5. Mark and remove drive shaft. Remove gearshift lever assembly. Support transmission. Disconnect rear insulator from transmission and remove crossmember. On 4WD models, disconnect and remove transfer case mounting bracket. Support insulator from transfer case.
  6. On all models, remove front engine insulator mounting nuts. Remove engine and transmission assembly.
scientia non olet · About LEMON Manuals