Drum Support: Reassembly
- Install OD valve and spring. Install new roll pin. Install Lubrication plug. Install one-way orifice. Install steel ball if used. See Figure
and Figure
. Mount oil pump assembly on Oil Pump Centering Tool (ST-2559-001). See Figure
. Mount OD case, gasket and drum support on oil pump.
- Ensure OD case assembly is inserted properly into oil pump. Loosen drum support bolts (if tightened). Insert Alignment Shaft (J33909), tapered edge first, completely through drum support. Rotate shaft to achieve proper alignment and torque drum support bolts. See Fig 1
.
Courtesy of MAZDA MOTORS CORP.
- On Nissan vehicles, check runout of drum support. Ensure support is within specified total indicator reading. See NISSAN DRUM SUPPORT RUNOUT SPECIFICATIONS
table. If not within specification, repeat step 2
.