LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1988 >> Precis Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.5L 4-CYL - VINS [J,K] & 1.6L 4-CYL - VIN [F] >> Removal & Installation >> Cylinder Head & Manifolds (1.6L) >> Installation

Cylinder Head & Manifolds (1.6L): Installation

  1. To install, reverse removal procedure. Tighten all parts to specification. Tighten cylinder head in 3 steps. On turbo models, before installing oil pipe flare nut, pour clean engine oil into turbocharger.
  2. Ensure turbocharger ring-to-exhaust manifold is installed. Ensure oil and vacuum hoses are properly installed and clamped. DO NOT reuse exhaust manifold or turbocharger gaskets. DO NOT use sealant on cylinder head gasket.
scientia non olet · About LEMON Manuals