LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1987 >> Van LS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL - VIN [G], 2.0L 4-CYL [D], 2.4L 4-CYL [L] >> Removal & Installation >> Engine - Colt Vista >> Installation

Engine - Colt Vista: Installation

NOTE: Replace drive axle shaft retainer ring each time drive axle shaft is removed.

To install, reverse removal procedure. Rear roll stopper insulator bolt should be installed after crossmember side has been mounted. Use care to align front engine mount locating holes without twisting insulator rubber. Tighten mounting bolts and nuts to specification with weight of engine on insulators. Replace all fluids, adjust all cables and linkages and check operation of gauges and meters.

scientia non olet · About LEMON Manuals