LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1985 >> Tredia L, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel - Standard >> Component Testing >> Oil Pressure Gauge >> Cordia, Starion & Tredia

Cordia, Starion & Tredia

  1. Turn ignition switch on (DO NOT  start engine). Wait 1-2 minutes and separate oil pressure sending unit connector from unit. Insert 120-ohm resister in series between gauge and ground. SeeFigure .
  2. Bulb should light and gauge should read about 60 psi (4.2 kg/cm2 ). If gauge does not have psi marks, needle should point at second of 2 center marks.
OIL PRESSURE GAUGE RESISTANCE

Application Ohms
Cordia & Tredia 40
Starion 120
scientia non olet · About LEMON Manuals