Fitting the manual transmission on engine
- Check the fitting sleeves (1) for correct seating and damage and replace if necessary.
- Position the engine (1) with the workshop crane and the special tool 0 490 579 (11 0 070) on the lifting table 2 184 136 .
- Guide out the workshop crane with the special tool 0 490 579 (11 0 070)
from the engine (1) and move it aside.
- Move the table top (B) in the arrow direction to the table top (A) and position the manual transmission (1) on the engine.
- Tighten the screws (arrows).TIGHTENING TORQUES SPECIFICATION
Transmission to engine M8 Tightening torque 19 Nm - Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Transmission to engine M8 Tightening torque 19 Nm