Removing the cylinder head cover
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING LEFT AND RIGHT WIPER ARM .
- Refer to REMOVING REAR HOOD SEAL .
- Refer to REMOVING SUSPENSION STRUT BRACE .
- Refer to REMOVING LEFT WINDSHIELD PANEL COVER .
- Refer to REMOVING RIGHT WINDSHIELD PANEL COVER .
- Refer to REMOVING BATTERY COVER .
- Refer to REMOVING THE SECOND FIREWALL AT TOP .
- Refer to REMOVING INTAKE PORT .
- Refer to REMOVING INTAKE SILENCER HOUSING .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING CLEAN AIR PIPE .
- Refer to IF INSTALLED: PARTIALLY REMOVING THE ENGINE VENTILATION LINE .
- Refer to REMOVING IGNITION COILS .
- Refer to REMOVING ALL SPARK PLUGS .
- Refer to REMOVING THE HIGH PRESSURE LINE BETWEEN THE RAIL AND THE HIGH PRESSURE PUMP .
- Refer to REMOVING HIGH PRESSURE PUMP .
- Refer to REMOVING INJECTORS .
- Refer to REMOVING BOTH ACTUATORS .
- Refer to REMOVING THE WHEEL .
- Refer to REMOVING THE FRONT RIGHT WHEEL ARCH COVER .
- Refer to REMOVING UNDERBODY PROTECTION .
Bolts of the cylinder head cover
NOTE:
RISK OF DAMAGE
Contaminant or foreign body
Contamination can result in malfunctions, loss of function or leaks
Contaminant or foreign body
Contamination can result in malfunctions, loss of function or leaks
- Adhere to the utmost cleanliness.
- Protect components from contamination e.g. by covering.
- Close off line connections with seal plugs.
- Unlock and loosen connector (1).
- Loosen clamp (2).
- Guide out wiring harness section (3) for the engine and set aside.
- Loosen screw (1).
- Guide out wiring harness section (2) for the engine and set aside.
- Loosen screw (1).
- Guide the coolant return line (2) out of the holder (3) and lay to one side.
- Evenly release all the screws in a sequence from (15) to (1).
- Feed out and remove the cylinder head cover (A).