1165 TURBOCHARGER (Cooper S)

1165 TIGHTENING TORQUE OVERVIEW

Control rod for electric wastegate valve controller
M6 Always use a second open-end wrench (for counter support) to tighten the lock nut!	Tightening torque	6 ± 0.3 Nm
Control rod for electric wastegate valve controller
M6 Always use a second open-end wrench (for counter support) to tighten the lock nut!	Tightening torque	6 ± 0.3 Nm
Electrical controller drive to exhaust turbocharger
Replace screws. Tighten screws crosswise.	Tightening torque	3 ± 0.5 Nm
Exhaust duct to holder
M6	Tightening torque	8 Nm
Exhaust turbocharger to cylinder head
M7 Replace screws. Replace nuts.	1. Joining torque	5 Nm
	2. Tightening torque	18 Nm
	Position the 3rd Tightening torque	18 Nm
Exhaust turbocharger to cylinder head
M7 Observe tightening sequence! Replace nuts.	1. Joining torque	10 Nm
	2. Tightening torque	10 Nm
	Position the 3rd Joining torque	16 Nm
	4. Tightening torque	16 Nm
	5. Tightening torque	16 Nm
Heat shield to console/heat shield
M6	Tightening torque	8 Nm
Heat shield to cylinder head
M8	Tightening torque	19 Nm
Heat shield to trim strip
M6	Tightening torque	8 Nm
Trim strip at the cylinder head
M7	Tightening torque	18 Nm