1165 TURBOCHARGER (Cooper JCW)

1165 TIGHTENING TORQUE OVERVIEW

Blow-off valve to exhaust turbocharger
M6	Tightening torque	9±1 Nm
Control rod for electric wastegate valve controller
M6 Always use a second open-end wrench (for counter support) to tighten the lock nut!	Tightening torque	6 ± 0.3 Nm
Control rod for electric wastegate valve controller
M6 Always use a second open-end wrench (for counter support) to tighten the lock nut!	Tightening torque	6 ± 0.3 Nm
Electrical controller drive to exhaust turbocharger
Replace screws. Tighten screws crosswise.	Tightening torque	3 ± 0.5 Nm
Exhaust duct to holder
M6	Tightening torque	8 Nm
Heat shield to console/heat shield
M6	Tightening torque	8 Nm
Heat shield to cylinder head
M8	Tightening torque	19 Nm
Heat shield to trim strip
M6	Tightening torque	8 Nm
Trim strip at the cylinder head
M7	Tightening torque	18 Nm