1112 CYLINDER HEAD (Cooper base)
1112 TIGHTENING TORQUE OVERVIEW
| Bearing journal to cylinder head | ||
| Bearing journal Replace the bearing journal! |
Tightening torque | 20 Nm |
| Cylinder head bolt to timing case cover | ||
| M8x40 Replace screws. |
Tightening torque | 19 Nm |
| Cylinder head cover to cylinder head | ||
| M6x27 | Joining torque | 8 Nm |
| Tightening torque | 10 Nm | |
| Cylinder head on device | ||
| M10X90x1.5 | Tightening torque | 30 Nm |
| Cylinder head to crankcase | ||
| M11 Observe tightening sequence! Fit new cylinder head bolts. |
1. Joining torque | 30 Nm |
| 2. Angle of rotation | 90° | |
| 3. Angle of rotation | 180° | |
| Engine mount to cylinder head | ||
| M10X45 | Tightening torque | 41 Nm |
| Flange on assembly jig | ||
| M14X30 | Tightening torque | 135 Nm |
| Screw plug on cylinder head | ||
| M28X1.5 | Angle of rotation | 60° |
| Screw plugs on cylinder head | ||
| M28X1.5 Replace the screw plugs. Wet the screw plugs with Loctite. (Loctite 243) |
Tightening torque | 25 Nm |
| Sliding rail to cylinder head | ||
| M6x16 | Tightening torque | 8 Nm |
| Special tool 00 2 320 to special tool 00 2 300 | ||
| M14X95 | Tightening torque | 130 Nm |
| Special tool 2 456 190 to cylinder head | ||
| M6X20 | Tightening torque | 8 Nm |
| Special tool 2 461 658 on cylinder head | ||
| Upper screws | Tightening torque | 5 Nm |
| Lower screws | Tightening torque | 10 Nm |
| Venting connector/special tool to cylinder head | ||
| M10 | Tightening torque | 18 Nm |