Installing the vibration damper
NOTE:
RISK OF DAMAGE
Radial shaft seal damage
When fitting the vibration damper, the radial shaft seal may be damaged
Radial shaft seal damage
When fitting the vibration damper, the radial shaft seal may be damaged
- It is imperative to use the special tool when fitting the vibration damper.
NOTE:
TECHNICAL INFORMATION
When removing/refitting or replacing the vibration damper, the radial shaft seal must also be replaced.
When removing/refitting or replacing the vibration damper, the radial shaft seal must also be replaced.
- Screw in the special tool 2 466 729
and hand-tighten it on the crankshaft.
- Insert and install the vibration damper (1) on the special tool 2 466 729
.
- Replace the screws (arrows).
Parts: Screws
- Hand-tighten the bolts (1).
- Guide the special tool 2 466 729
out and remove.
- Feed in vibration damper (1) and install.
- Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Vibration damper with belt pulley to crankshaft | ||
|---|---|---|
| M10 Replace screws. |
1. Joining torque | 40 Nm |
| 2. Angle of rotation | 120° | |
- Release screws, and feed out and remove special tool 0 493 587 (11 8 180)
.
- Tighten transmission screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Transmission bolts | ||
|---|---|---|
| Torx screw BM8x40 | Tightening torque | 19 Nm |
- Feed in protective cap (2) and install.
Follow-up work
- Refer to INSTALLING DRIVE BELT .
- Refer to INSTALLING THE FRONT WHEEL ARCH COVER .
- Refer to INSTALLING THE FRONT RIGHT WHEEL .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING CROSS CONNECTION .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING INTAKE PORT .