Remove drive belt
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work
- Refer to REMOVING INTAKE PORT .
- Refer to REMOVING INTAKE SILENCER HOUSING .
- Refer to REMOVING CROSS CONNECTION .
- Refer to REMOVING FRONT RIGHT WHEEL .
- Refer to REMOVING FRONT WHEEL ARCH COVER .
CAUTION:
Spring preload
.
Injury hazard!
Injury hazard!
- The use of the specified special tool (tool) is mandatory.
- Carry out the described steps properly.
CAUTION:
Component with preload
.
Injury hazard!
Injury hazard!
- Reduce preload as far as possible before disassembly. Relieve component.
NOTE:
TECHNICAL INFORMATION
If the drive belt is reused: Mark the direction of rotation and reinstall the drive belt in same direction of rotation.
If the drive belt is reused: Mark the direction of rotation and reinstall the drive belt in same direction of rotation.
NOTE:
TECHNICAL INFORMATION
Replace drive belt if it is contaminated with coolant and oil residue.
Replace drive belt if it is contaminated with coolant and oil residue.
- When reusing drive belt: Mark the direction of rotation.
- Elevate preload of the belt tensioner on the hexagon head (1) in direction of arrow until the bore holes align.
- Secure the belt tensioner with the special tool 0 496 268 (11 0 390)
.
- Remove drive belt (1).