Checking the end stops of the electrical wastegate valve controller

• Carry out the following steps only if the check of the end stops of the electrical wastegate valve controller is predefined by the vehicle diagnosis.
• Connect diagnostic system:
  • Service functions
  • Power train
  • Engine electrical system
  • Adjustment programs
  • Checking the end stops of the wastegate linkage

Follow-up work 

• Refer to INSTALLING THE HEAT SHIELD ON THE EXHAUST TURBOCHARGER, TOP .
• Refer to INSTALLING THE FRONT RIGHT WHEEL .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .
• Refer to INSTALLING THE OXYGEN SENSOR MONITOR .
• Refer to INSTALLING LAMBDA OXYGEN SENSOR .
• Refer to INSTALLING BATTERY CARRIER .
• Refer to INSTALLING E-BOX .
• Refer to INSTALLING THE SYSTEM BATTERY .
• Refer to CONNECTING THE NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
• Refer to INSTALLING CLEAN AIR PIPE .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING INTAKE SILENCER HOUSING .
• Refer to INSTALLING INTAKE PORT .
• Refer to INSTALLING THE REAR BULKHEAD .
• Refer to INSTALLING THE UPPER BULKHEAD COVER PANEL .
• Refer to INSTALLING THE STRUT BRACE .
• Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
• Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .