Installing the guide for rear bumper cover
- Feed the guide (4) in.
- Tighten nuts (2) and (3).TIGHTENING TORQUE SPECIFICATIONS
Guide for rear bumper panel Nut 3.5Nm screw 2.5Nm - Connect and lock the connector (1) and clip into the corresponding wiring harness
- Tighten down screws (1).TIGHTENING TORQUE SPECIFICATIONS
Guide for rear bumper panel Nut 3.5Nm screw 2.5Nm - Right side only:
Connect plug (1).
- Equipment specification with contactless trunk opening:
Clip in the holder (4) with the detents (3).
Connect connectors (1) and lock.
Tighten the screws (2).
TIGHTENING TORQUE SPECIFICATIONSHolder for control unit/sensor lines for contactless trunk opening Screw tightening torque 2.5Nm