Installing replacement transmission (8-speed, AISIN GA8F22AW) (Cooper Clubman S and JCW)
IMPORTANT:
Transmissions are filled with fluid. Oil level does not have to be compensated!
Only in the event of discernible external damage to replacement transmission or discernible oil leakage from replacement transmission - check OIL LEVEL .
After completing work:
- Use only the approved automatic transmission oil: ATF6 (BMW/MINI part number 83 22 2 355 599).
- Reset adaptation values.
- Perform clutch and gear ratio adaptation.
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Recycling:
Catch and dispose of leakage transmission oil.
Observe country-specific waste disposal regulations
Preliminary work needed:
- Remove AUTOMATIC TRANSMISSION (without wheel alignment!).
Remount the following parts.
- Converter, transportation retainer (1).
- Remount the gear selector cable holder
IMPORTANT:
In the case of a transmission replacement, the associated HEAT EXCHANGER/TRANSMISSION OIL COOLER must always be replaced as well.
Failure to comply with this instruction may result in serious damage to the automatic transmission.
Required follow-up work:
- Install AUTOMATIC TRANSMISSION (without wheel alignment!).