Adjusting selector lever (6-speed, AISIN GA6F21AW) (Cooper Clubman base FWD)
IMPORTANT:
An incorrectly adjusted gearshift mechanism can result in tooth meshing noises be transmitted into the passenger compartment.
Preliminary work needed:
- Shift selector lever into "P" position
- Remove INTAKE FILTER HOUSING .
Removal:
Remove screw (1).
The head piece for tolerance compensation must be easily moveable before installation.
Release ball socket (1) from ball pivot.
Release cable (2) from support angle.
Position "P" of selector lever (1) is the rearmost locked position.
Installation:
Press in cable (2) into support angle.
Ensure cable counter support audibly engages.
Press on ball socket (1) onto ball pivot.
Tighten screw (1).
Tightening torque 24 51 1AZ .
Required follow-up work:
- Install INTAKE SILENCER HOUSING .