Fill/inflate tire
TECHNICAL INFORMATION Observe country-specific regulations and the regulations of the trade associations.
- Remove all installation aids.
- Utilize the options to safely mount the wheel. Place the wheel into a holding device.
- Inflate tire with air (without valve insert).
- Increase the pressure up to 3.3 bar in stages (fitting pressure).
- If the tire bead does not slip on to the rim flange all round: Do not increase the pressure under any circumstances.
- If necessary, release air and force off tire bead again.
- Apply coating of tire-lining past to rim flange and tire again.
- Inflate the tire again up to 3.3 bar.
- If the tire bead is mounted correctly onto rim flange: Increase the tire pressure to a maximum of 4.0 bar set pressure.
- Screw in the valve insert and tighten to torque.
- Correct tire pressure.