LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2024 >> Cooper Clubman JCW ALL4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Body Equipment - Repair -- F55) >> General And Safety Information >> Notes on installation of rubber window seals

Notes on installation of rubber window seals

WARNING: This page is about a different car, the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
  1. Work safety when handling lubricant G14* 
    • Wear safety goggles, hand protection and if necessary an apron.
    • Do not eat, drink or smoke in the area of processing/application
    • Ensure rooms are well ventilated.
    • Keep away from heat and ignition sources
    • In event of skin contact: Wash areas of skin affected with soap and water immediately, change lubricant contaminated work clothes immediately (keep spare work clothes in reserve)
    • In event of eye contact: Rinse eyes immediately with plenty of water and seek medical advice
    • Observe the safety data sheet
  2. General notes 
    • Use approved lubricant for installation only
    • Application only at room and object temperatures between 18 and 25 °C
    • Lubricant dries at different rates depending on the quantity, temperature and ventilation and becomes sticky
    • Lubricant can only be used for installation and not for fault elimination (e.g. grating)
    • Newly painted parts may only be brought into contact with the lubricant after cooling
    • Optimal bonding to the surface is achieved after approx. 48 h. The rubber window seal must not be exposed to mechanical strain beforehand. (car wash, strength test, etc.).
    IMPORTANT: To avoid creaking, do not use soapy water (low-surface-tension water with dish soap) or lubricant containing silicone.
  3. Auxiliary materials and tools 
  4. Preparations 
    • Heat and remove anti-friction agent residues with a hot air blower or clean new part thoroughly
    • Immediately prior to installation, clean the work area in order to remove silicone and grease residues
    NOTE: Air drying time approx. 1 min:
  5. Assembly 
    • Apply a thin coating of lubricant to the rear of the rubber window seal only
    • Perform installation within 30 min of applying lubricant
    • Lubricant dries after installation and becomes sticky
scientia non olet · About LEMON Manuals