11 37 005 Removing and installing/replacing eccentric shaft (B36A/B38A)

Special tools required: 

• 11 4 480

Necessary preliminary tasks: 

• Remove INTERMEDIATE LEVER 
• Remove INTAKE CAMSHAFT 
• Remove SERVOMOTOR FOR ECCENTRIC SHAFT 

Removal: 

Release screws (1).

Set down the bearing cap neatly in special tool 11 4 480 .

Release all screws (2) evenly.

Set down all bearing supports neatly in special tool 11 4 480 .

Fig 1: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove intermediate shaft (1) from cylinder head.

Fig 2: Removing Intermediate Shaft From Cylinder Head

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Check all needle bearings (2) of eccentric shaft (1) for ease of movement.

Fig 3: Locating Needle Bearings Of Eccentric Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Clean all bearing positions (1) and coat with engine oil.

Fig 4: Locating Bearing Positions

Courtesy of BMW OF NORTH AMERICA, INC.

Before assembly of the eccentric shaft move the needle bearing (1) in the direction of the arrow up to the limit position.

Fig 5: Moving Eccentric Shaft Needle Bearing Up To Limit Position

Courtesy of BMW OF NORTH AMERICA, INC.

Oil the needle bearings of eccentric shaft (1).

Mount eccentric shaft on cylinder head.

Mount bearing shell (2) and bearing supports (3) on cylinder head.

Fig 6: Mounting Bearing Shell And Bearing Supports On Cylinder Head

Courtesy of BMW OF NORTH AMERICA, INC.

The bearing cap (1) is provided with a limit position.

Fig 7: Locating Bearing Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten all screws (1 and 2) evenly.

Tightening torque 11 37 3AZ .

Fig 8: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.