REP-TAT-P-241 1-25 Seal/replace the cover (oil pan) for the switching device (8-speed, AISIN GA8F22AW)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When the engine is stopped after the completion of trip, it may be necessary to run the electric fan. In rare cases, operation of the electric fan can last up to 11 min. This protects the components. In this case, replacing the electric fan will not remedy the problem!
Necessary preliminary work:
- Refer to DISCONNECTING THE BATTERY GROUND LEAD
- Refer to REMOVING INTAKE PORT
- Refer to REMOVING INTAKE SILENCER HOUSING
- Refer to REMOVING CROSS CONNECTION
- Drain the oil from the transmission
- Refer to REMOVING FAN COWL WITH ELECTRIC FAN
Remove the cover (oil pan) for the switching device (8-speed, AISIN GA8F22AW)
NOTE:
TECHNICAL INFORMATION
The transmission oil pan must be replaced each time it is released.
The transmission oil pan must be replaced each time it is released.
- Loosen screws (2).
- Remove the cover (1).
Install the cover (oil pan) for the switching device (8-speed, AISIN GA8F22AW)
- Clean the sealing surface on the transmission.
- Replace the cover (1).
Pats: Cover, rubber seal
- Insert a new rubber seal into the new cover (1).
- Position the new cover (1).
- Tighten the screws (2).
TIGHTENING TORQUE SPECIFICATION
| Cover (oil pan) on transmission (8-speed, AISIN GA8F22AW) | |
|---|---|
| M6 | |
| Tightening torque | |
| 7 Nm | |
Follow-up work:
- Refer to INSTALLING FAN COWL WITH ELECTRIC FAN
- Refer to CONNECTING THE BATTERY GROUND LEAD
- Refer to REPLENISHING THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION (8-SPEED, AISIN GA8F22AW)
- Refer to INSTALLING CROSS CONNECTION
- Refer to INSTALLING INTAKE SILENCER HOUSING
- Refer to INSTALLING INTAKE PORT