Replacing front ride height sensor (Cooper Convertible)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Preliminary work needed:

Turn steering wheel to right.

Removal:

Unlock connector (1) and disconnect.

Unscrew nut (3).

Detach the jointed rod on the lever of the sensor.

Release screw (2).

Remove ride height sensor (4).

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew the screws (1).

Remove holder (2) from ride height sensor.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Align holder (2) to ride height sensor.

Tighten down screws (1).

Tightening torque 37 14 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Align ride height sensor (4) with holder on front axle support.

Tighten screw (2).

Tightening torque 37 14 2AZ .

Insert jointed rod on ride height sensor.

Tighten nut (3).

Tightening torque 37 14 4AZ .

Insert connector (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Check HEADLIGHT ADJUSTMENT , correct if necessary.