Removing and installing/replacing EDC control unit (SAS control unit) (Cooper Convertible)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The optional equipment system (SAS) is a control unit in which the functions of the suspension control systems and the assist systems are integrated.

(In the AW System and in the appropriate BMW Parts Catalog, the control unit can be found under main group 34.)

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)! .

Preliminary work needed:

Disconnect BATTERY GROUND LEAD.

Removal:

Remove cover (1) of right luggage compartment trim panel.

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect plugs (1).

Loosen screws (2).

Remove SAS control unit (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Connect and lock connector (1).

Position SAS control unit (3).

Tighten down screws (2).

Tightening torque 37 14 6AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Install cover (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Connect BATTERY GROUND LEAD.
Replacement only: Perform the PROGRAMMING/CODING .