Instructions for desiccant insert replacement
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 32 1 270
A desiccant insert need not be changed at regular inspection intervals in a well-functioning, sealed air conditioning system.
However, the dryer flask or desiccant insert must absolutely be replaced in the event of:
- contamination of the refrigerant with shavings (e.g. when the compressor is clamped).
- With depressurized and/or completely drained refrigerant circuit.
- In case of a refrigerant circuit, which was closed using special tool 32 1 270 but remains open for more than 24 hours.
The desiccant insert cannot be replaced in the following vehicles:
- 1-Series E8x, 3-Series E9x from 12/2008
- E84 , E89
- F series
- G series
- BMW i without heat pump
In these vehicles, the condenser for the heating and air conditioning system must be replaced.
- BMW i 01 with heat pump
On this vehicle the low pressure battery must be replaced.