Removing and installing/replacing all spray nozzles of windshield washer system (Cooper Convertible)

Preliminary work needed: 

• If necessary, remove damping layer on ENGINE COMPARTMENT LID .

Removal: 

Removing the spray nozzle:

Unlock and disconnect hose (1).

Unlock and disconnect plug (2) as required.

Release the retaining lugs and feed the spray nozzle (3) out from the hood.

Courtesy of BMW OF NORTH AMERICA, INC.

Removing the hose pipe:

Unclip the hose pipe (1).

Release the hose connector (2) and feed the hose pipe (1) out.

Courtesy of BMW OF NORTH AMERICA, INC.

Removing the hose pipe: 

Unlock and disconnect the hose pipe from the connector (1).

Feed the hose pipe out.

Unlock and disconnect plug (2) as required.

If necessary, feed out cable.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Installing the hose pipe: 

Feed the hose pipe in.

Connect and lock the hose pipe on the connector (1).

If necessary, feed in cable.

If applicable, connect the connector (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the hose pipe: 

Feed the hose pipe (1) in and fit the hose connector (2).

Clip in the hose pipe (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the spray nozzle: 

Join spray nozzle (3) in engine compartment lid.

Connect hose (1).

If applicable, connect the connector (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• If necessary, install damping layer on ENGINE COMPARTMENT LID .