Checking fuel delivery pressure

Special tools required:

13 5 270
11 4 310
11 5 364
13 3 060

IMPORTANT: Lines are under pressure!

Wear safety goggles and gloves.

Gas can emerge spontaneously at high velocity when the fuel line is released!

Recycling:

Catch and dispose of leakage fuel with auxiliary materials.

Observe country-specific waste disposal regulations.

Preliminary work needed:

Connect MINI diagnostic system to the appropriate scan tool.
Remove ACOUSTIC COVER .

Installing special tool:

Unfasten fuel line (1) and disconnect.

Catch and dispose of leakage fuel with auxiliary materials.

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew adapter (1) from special tool 13 5 270.

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 13 5 270 into disconnected fuel line.

Screw onto special tool 13 5 270, the special tool 11 4 310.

Screw the 11 4 310 IMIB 100 bar pressure sensor (1) onto the special tool (In) .

NOTE: The 25 bar pressure sensor can also be used as an alternative to the IMIB 100 bar pressure sensor (1) (Integrated Measurement Interface Box) . For this, screw on special tool 11 5 364 instead of special tool 11 4 310 onto special tool 13 5 270. Or directly screw the pressure manometer from the set of special tools 13 3 060 onto the special tool 13 5 270.

Courtesy of BMW OF NORTH AMERICA, INC.

Establish fuel delivery pressure. Read the fuel delivery pressure on the In and compare it with the values in the MINI diagnostic system using an appropriate scan tool.

Removing special tool:

On completion of measurement, disconnect and remove special tool 13 5 270.

Catch and dispose of leakage fuel with auxiliary materials.

Connect fuel line (1).

Fuel line (1) must audibly engage.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Check fuel system for leak tightness.
Install ACOUSTIC COVER .