Mounting engine on assembly jig (B38 engine) (Cooper Clubman base)

Special tools required:

IMPORTANT: Follow manufacturer's instructions.

Preliminary work needed:

Unscrew the screws (1).

Remove adapter plate (2).

NOTE: Tightening torque: 11 11 5AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Prepare special tool 00 2 300 together with special tool 00 2 320 (00 2 321).

Courtesy of BMW OF NORTH AMERICA, INC.

Prepare special tool 2 288 357 together with special tool 11 9 030.

Courtesy of BMW OF NORTH AMERICA, INC.

Lift engine (1) with workshop crane and special tool 11 0 070 from table lift (83 22 2 184 136).

Courtesy of BMW OF NORTH AMERICA, INC.

Lift engine with workshop crane onto assembly jig.

Courtesy of BMW OF NORTH AMERICA, INC.

Bolt special tools 11 9 030 and 2 288 357 to engine.

Tightening torque: 11 11 5AZ .

Fix special tool 11 9 030 to assembly jig 00 2 300.

Tightening torque: 11 11 6AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Suspend engine from workshop crane
Remove engine from assembly jig
Use workshop crane to place engine on table lift
Install transmission. Refer to the appropriate procedure:
- For automatic transmission with FWD, refer to REMOVING AND INSTALLING TRANSMISSION (6-SPEED, AISIN GA6F21AW)
- For automatic transmission with AWD, refer to REMOVING AND INSTALLING TRANSMISSION (8-SPEED, AISIN GA8F22AW)
- For manual transmission with FWD, refer to REMOVING AND INSTALLING TRANSMISSION (GS6-58BG)
- For manual transmission with AWD, refer to REMOVING AND INSTALLING THE TRANSMISSION (GS6X60DA/BA)
Install ENGINE with transmission
Top up motor oil. Refer to MOTOR OIL CHANGE (B38) .