Removing and installing (replacing) control unit for contactless trunk opening

Attention! 

Observe the INFORMATION  on protection from electrostatic discharge.

Preliminary work needed: 

• Remove REAR BUMPER PANEL .

Removal: 

Unlock and disconnect the connector (1).

Release detent (2) and remove the control unit (3) in arrow direction

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Connect all connectors (1).

Insert and clip in the control unit (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install REAR BUMPER PANEL .