REP-TAT-P-5218-25 When replacing the seat frame: Remount components
- Removing the LATCH anchor for the front passenger seat NOTE: The operations shown only for one side must be carried out on both sides.
- Drill out the blind rivets (1).
- Remove the LATCH anchor (2) for the front passenger seat.
- Removing front lower strap NOTE: TECHNICAL INFORMATION:
Different variants may be installed depending on the vehicle equipment.- Loosen screw (1).
- Unclip the cable clip (2).
- Feed the cable (1) out of the seat mechanism.
- Release cable tie (1).
- Carefully unlock the detents (markings).
- Thread the matching connector plugs (2) in the direction of the arrow out of the connector plug housings (3).
- Installing the front lower strap NOTE: TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.- Insert the appropriate connectors (1) into the connector housing (2) and clip them in.
- Fasten the cable (3) on the connector housing (2) using a cable tie.
- Hook the cable (1) into the seat mechanism.
- Replace the screw (1).
Parts: Screw
- Tighten down screw (1).
- Clip in the cable bracket (2).
- Installing the LATCH anchor for the front passenger seat
- Position the ISOFIX anchor (2) for the front passenger seat.
- Replace blind rivets (1).
Parts: Blind rivet
NOTE: The operations shown only for one side must be carried out on both sides. - Secure the ISOFIX anchor (2) for the front passenger seat using blind rivets (1).