Removing and installing or replacing rear carpet on seat pan

Preliminary work needed: 

• Remove both front seats. Refer to: FRONT SEAT, DRIVER'S SIDE and FRONT SEAT, PASSENGER'S SIDE .
• Remove REAR SEAT BENCH .
• Remove TRIM PANEL  for door pillar bottom on the left and right sides
• Remove complete CENTER CONSOLE .
• Remove central bass speaker trim. Refer to: CENTRAL BASS ON THE PASSENGER'S SIDE (UNDER THE FRONT SEAT) and CENTRAL BASS LOUDSPEAKER ON DRIVER'S SIDE (UNDER FRONT SEAT)

Removal: 

Lift off carpet (1) towards the top and remove it from the vehicle.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Replacement: 

Lay removed carpet over new one and transfer cuts to new carpet (if necessary).

Install the carpet (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install both front seats. Refer to: FRONT SEAT, DRIVER'S SIDE and FRONT SEAT, PASSENGER'S SIDE .
• Install REAR SEAT BENCH .
• Install TRIM PANEL  for lower door pillar on the left and right sides
• Install CENTER CONSOLE  completely.
• Install central bass speaker trim. Refer to: CENTRAL BASS ON THE PASSENGER'S SIDE (UNDER THE FRONT SEAT) and CENTRAL BASS LOUDSPEAKER ON DRIVER'S SIDE (UNDER FRONT SEAT)