Remove and install (replace) telematics control module (Cooper)

Preliminary work needed:

Removal:

Release detents and pull telematics control module (1) out of holder (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect connector (1).

Remove telematics control module (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Connect plug (1) with telematics control module (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Slide telematics control module (1) into holder (2).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: When replacing the telematics control module check whether the faulty telematics control module is equipped with an EMERGENCY BATTERY :

if no , then the new part is installed without an emergency battery !
If yes , ten the new parts is to be equipped with a new emergency battery (separate order, telematics control module is shipped without an emergency battery!)

Required follow-up work:

Replacement: