Installing the engine on the assembly jig
CAUTION:
Heavy component.
Heavy components can lead to injury or damage.
Heavy components can lead to injury or damage.
- Remove and install heavy components with the aid of another person/other persons.
- Loosen screws (1).
- Guide out and remove holder (2).
- Position the special tool 2 455 010 on the engine (1).
- Position the standard screws (arrows).
- Tighten the standard screws (arrows).TIGHTENING TORQUES SPECIFICATION
Special tool 2 455 010 to crankcase M10x30 Tightening torque 38 Nm - Prepare the assembly stand 0 495 187 (00 2 300)
with the special tool 0 495 196 (00 2 320)
.
- Tighten the screws (arrows).TIGHTENING TORQUES SPECIFICATION
Special tool 00 2 320 to special tool 00 2 300 M14X95 Tightening torque 130 Nm - Screw special tool 2 413 082 together with special tool 0 495 196 (00 2 320) .
- Tighten the screws (arrows).TIGHTENING TORQUES SPECIFICATION
Special tool 11 8 930 to special tool 00 2 320 M14x35 160 Nm - Position the workshop crane with the special tool 0 490 579 (110 070)
and the engine on the special tool 0 495 187 (00 2 300).
- Detach the holder (2) in the direction of the arrow.
- Position the engine (1) with the special tool 2 455 010
in the direction of the arrow on the special tool 2 413 082.
- Lock the holder (1) in the direction of the arrow.
- Tighten nuts (2).