Secure mounted parts on the front axle support
NOTE:
Perform the steps on the right and left side.
- Replace screws (1).
Parts: Screws
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATION
Holder, wishbone rubber mount, to body M10 screw Replace screw. Joining torque 56 Nm Angle of rotation 90° - Position engine mount (3) on the front axle support (1).
- Tighten down screw (2).TIGHTENING TORQUES SPECIFICATION
Holder with rubber mount to front axle support M12 screw 100 Nm
NOTE:
Perform the steps on the right and left side.
- Position lock (2).
- Lock the fuse (1) of the lock (2) from the holder for the charge air cooler.
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Bottom deformation element to adapter plate for front axle support Tightening torque 11.8 Nm - Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Bottom deformation element to adapter plate for front axle support Tightening torque 11.8 Nm - Position the holder for the washer fluid reservoir (2).
- Tighten down screws (3).TIGHTENING TORQUES SPECIFICATION
Washer fluid reservoir holder to adapter plate of front axle support Tightening torque 10 Nm