Remove EME
NOTE:
TECHNICAL INFORMATION
After disconnecting, seal the high-voltage connector with the cover caps from the set of special tools 5A4A589.
After disconnecting, seal the high-voltage connector with the cover caps from the set of special tools 5A4A589.
Preliminary work
- Refer to DISCONNECTING PLUG CONNECTIONS .
- Refer to REMOVING THE HOLDER FROM THE HEATER VALVE .
- Refer to DETACHING THE COOLANT HOSE .
- Refer to RELEASING THE REFRIGERANT LINE ON THE HEAT EXCHANGER .
- Refer to DISCONNECTING THE PLUG CONNECTION AT THE ELECTRIC COOLANT PUMP .
- Refer to DISCONNECTING THE HIGH-VOLTAGE PLUG CONNECTION ON THE KLE .
- Refer to DISCONNECTING COOLANT HOSES .
- Refer to REMOVING THE TENSIONING RELIEF .
- Refer to UNLOCKING AND DISCONNECTING HIGH-VOLTAGE PLUG CONNECTION ON ELECTRICAL MACHINE ELECTRONICS (EME) .
- Refer to RELEASING THE POTENTIAL EQUALIZATION LINE ON THE CONNECTION HOUSING .
- Refer to REMOVING THE ASSEMBLY FRAME FROM THE DRIVE UNIT .
- Refer to DISCONNECTING THE HIGH-VOLTAGE PLUG CONNECTIONS ON THE SIDE OF THE EME .
- Refer to DISCONNECTING THE HIGH-VOLTAGE PLUG CONNECTION AT THE TOPPING OF THE EME .
- Refer to REMOVING THE CABLE CLIP ON THE SIDE OF THE EME .
- Refer to PULLING OFF THE COOLANT LINE ON THE SIDE OF THE EME .
- Refer to REMOVING THE LID ON THE SIDE OF THE EME .
- Refer to RELEASING THE CONDUCTOR LINES FROM THE ELECTRICAL MACHINE ELECTRONICS (EME) .