Remove engine bridge
CAUTION:
Heavy component.
Heavy components can lead to injury or damage.
Heavy components can lead to injury or damage.
- Remove and install heavy components with the aid of another person/other persons.
- Release spindle screw (3) from the engine bridge
- Release hook (2) and (3).
- Guide out the engine bridge from the vehicle and remove with the help of a second person.
- Loosen the screws (1) from the special tools 2 459 012 .
- Guide out and remove the special tool 2 459 012 on the cylinder head.
- Guide in and install cover (1) on left and right.
Installing left and right cover caps with EDC
NOTE:
The operations shown only for one side must be carried out on both sides.
- Install the cover (2).
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
- Install the protective cap (1).
Follow-up work
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE UPPER BULKHEAD COVER PANEL .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .