36 10 508 Stationary wheel balance (Countryman 2017-2023, except PHEV)

Special tools required:

36 1 010
36 1 020

Preliminary work needed:

Remove wheel

IMPORTANT: Use only BMW-approved balance weights.

Remove any fitted balancing weights, stones in tread pattern and larger contaminants.

Check tire pressure, check tire for condition, damage, flat spots (out-of-round caused by e.g. stopping the car with hot tires); if necessary, check wheel and tire for radial and axial runout.

Courtesy of BMW OF NORTH AMERICA, INC.

Use BMW-approved wheel centering of relevant balancing machine manufacturers.

Base flange
Wheel centering element
Type flange
Clamping nut

Also refer to applicable BMW Workshop Equipment.

IMPORTANT: To avoid retooling errors, it will be necessary to fit the wheel on the balancing machine in the same way (e.g. valve facing down) as it is then fitted on the car. Balance wheel in accordance with operating instructions of relevant balancing machine.

Courtesy of BMW OF NORTH AMERICA, INC.

On light-alloy rims with distinctive J-shape rim flange, proceed as follows:

Gently press off tire sidewall with special tool 36 1 020 at appropriate point from rim flange.
Install retaining clamp (1).
Remove special tool 36 1 020.

Courtesy of BMW OF NORTH AMERICA, INC.

Raise retaining clamp with special tool 36 1 010. Slide balance weight underneath and allow it to snap into place.

Courtesy of BMW OF NORTH AMERICA, INC.

Arrangement of balance weights for light-alloy rims with distinctive J-shape rim flanges.

retaining spring
Balance weight

Adhesive weights must be used on all other light-alloy rims.

Max. imbalance per wheel.

NOTE: When using adhesive weights, proceed as follows:

Carefully remove any adhesive weights. Do not damage rim when doing so.
Select suitable location for lining.
Clean adhesive area thoroughly.

Courtesy of BMW OF NORTH AMERICA, INC.