Install right charge air line

• Check sealing ring (1) for damage, replace if necessary.

  Parts:  Sealing ring

  Courtesy of BMW OF NORTH AMERICA, INC.

• Let the lock (1) engage at the holder (arrow).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the charge air duct (1) at the side through the wheel well between the side member and adapter of the front subframe.
• Push past the lower section of the charge air line on the charge air cooler.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install the upper section of the charge air line (1) past the wheel arch to the exhaust turbocharger.
• Feed in the lower part of the charge air line (2) and connect to the charge air cooler.
• Bring the right front adapter of the front subframe (1) in initial position.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach the pressure pipe to the charge air cooler until the lock (1) snaps in on both sides.

  The lock (1) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach charge air duct to exhaust turbocharger until locks (1) engage on both sides.

  The lock (1) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install cross connection (3).
• Install the locks (2).
• Lock the locking pins (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screw (2) of the cross connection at the right front.
  TIGHTENING TORQUES SPECIFICATION
  
  

  Bottom deformation element to adapter plate for front axle support
  	Tightening torque	11.8Nm

• Replace the blind rivets (1) of the cross connection and rivet them.

  Parts:  Blind rivet

• Tighten the screws (2) of the front left cross connection.

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUES SPECIFICATION
  
  

  Bottom deformation element to adapter plate for front axle support
  	Tightening torque	11.8Nm

• Replace blind rivets (1) for cross connection and rivet.

  Parts:  Blind rivet

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten screws (1) on adapter of front subframe.
  TIGHTENING TORQUES SPECIFICATION
  
  

  Adapter, front axle support to front axle support
  Screw	tightening torque	100Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten screws (1) of charge air duct at oil pan.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE FRONT RIGHT WHEEL ARCH COVER .
• Refer to INSTALLING THE FRONT RIGHT WHEEL .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .