Remove oil sump
WARNING:
Hot fluids.
Risk of scalding!
Risk of scalding!
- Conduct all work in the vehicle wearing appropriate personal protective equipment only.
CAUTION:
Materials harmful to health.
Contact with fluids harmful to health!
Contact with fluids harmful to health!
- Note and follow safety instructions on containers.
- Conduct all work in appropriate personal protective equipment only.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE OIL FILLER CAP .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING STARTER MOTOR .
- Refer to RELEASING THE OIL DRAIN PLUG .
- Refer to TIGHTENING THE OIL DRAIN PLUG .
- Refer to REMOVING FRONT RIGHT WHEEL .
- Refer to REMOVING THE FRONT RIGHT WHEEL ARCH COVER .
WARNING:
Car may slip off the vehicle hoist where components are supported.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Secure the vehicle hoist against lowering and lifting.
- Make sure that the vehicle does not lift off the mounting plates on the vehicle lift.
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
RISK OF DAMAGE
Contaminant or foreign body.
Contamination can result in malfunctions, loss of function or leaks.
Contaminant or foreign body.
Contamination can result in malfunctions, loss of function or leaks.
- Adhere to the utmost cleanliness.
- Protect components from contamination e.g. by covering.
- Close off line connections with seal plugs.
- Loosen screws (1).
- Guide the line (2) out and set it aside.
- Loosen screw (1).
- Guide out and remove holder (2).
- Unlock and loosen connector (3).
- Feed out the positive battery cable (4) from the clamps (5) and set it aside.
CAUTION:
Component with heavy weight.
Injury hazard!
Injury hazard!
- Note component's center of gravity.
- Support component using a jack.
- Secure component against falling off the jack.
- Support engine with a suitable jack.
- Loosen screws (1).
- Loosen screw (2).
- Guide out and remove holder (3).
- Unscrew bolts (1) from transmission.
- Unscrew screws (2) to (17).
- Detach the oil pan in area (1) with cut-out carefully .
NOTE:
TECHNICAL INFORMATION
Increased force may be necessary during disassembly because the component is bonded with liquid sealing compound.
Increased force may be necessary during disassembly because the component is bonded with liquid sealing compound.
- Position standard mounting lever (1) at the provided point between crankcase (3) and oil pan (2).
- Detach the oil pan (2) with a standard mounting lever (1) from the crankcase (3)carefully in the direction of the arrow.