Installing hot film air mass meter

• Insert and install the hot film air mass meter (2)  .
• Tighten screws (arrows).
  TIGHTENING TORQUES SPECIFICATIONS
  
  

  Hot film air-mass meter to intake filter housing
  Screw TS4x16	Tightening torque	1.5 Nm

• Connect and lock the connector (1)  .

  The connector (1)  must engage audibly.

For replacement: Reset adaptation values 

• Reset the adaptation values with the diagnostic system:
  • Drive
  • DME
  • Reset adaptations
  • Delete adaptations

Courtesy of BMW OF NORTH AMERICA, INC.