Installing acoustic cover
NOTE:
RISK OF DAMAGE
Damage to the acoustic cover/design cover.
Jerky movements during disassembly and application of excessive force during installation may result in breakage of the acoustic cover/design cover.
Damage to the acoustic cover/design cover.
Jerky movements during disassembly and application of excessive force during installation may result in breakage of the acoustic cover/design cover.
- Disassemble or mount the acoustic cover/design cover carefully.
- Disassemble or mount snap-lock couplings of the ball pivots one after the other.
- Disassemble or mount the acoustic cover/design cover only at temperatures >20°C.
- Use only distilled water as an auxiliary material during installation, no lubricants.
- Check the correct installation of all rubber mounts (1) in the acoustic cover.
- Clip acoustic cover (1) into the holders in the marked areas.
- Make sure that the acoustic cover (1) snaps in audibly.