51 43 070 Removing and installing/replacing side trim panel, footwell, on A-pillar, left (Cooper 4-door hatchback and Cooper 2-door hatchback, 2020-2023)

Preliminary work needed: 

• Remove FRONT DOOR SILL COVER STRIP (INSIDE) .

Removal: 

Detach edge protection (4) in area of side trim panel (1).

Remove screw (3).

Lever hood release (2) from side trim panel (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Remove screw (1).

Release and remove the side trim panel (3) from the clips (2) in the arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

If necessary, take out clips (1) remaining in bores.

Replace faulty clips (1).

Place and clip in the side trim panel (2) with preinstalled clips (1) on the associated bores.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Mount hood release (1) and tighten the screw (3).

Ensure side trim panel (1) is correctly fitted for the edge protection (4).

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking: 

• Install FRONT DOOR SILL COVER STRIP (INNER) .